Decoration of phosphoric acid groups onto Ti3C2Tx MXene for enhanced uranium removal

The construction of novel MXene-based composites with superb abilities through functionalization is an effective strategy to enhance the potential of this emerging inorganic lamellar material for environmental adsorption applications. The present work systematically investigated the adsorption performance of Ti3C2Tx MXene modified with phosphate functional groups that facilitate the capture of uranyl ions. After introducing phosphate groups via a two-step modification of 3-aminopropyltriethoxysilane (APTES) and phytic acid (PA), the synthesized Ti3C2-APTES-PA is significantly superior to pristine Ti3C2Tx nanosheets in terms of adsorption capacity, adsorption selectivity and reusability for uranium. The maximum uptake capacity of Ti3C2-APTES-PA at pH = 5 reaches 323 mg/g, which is 2.5 times higher than that of unmodified MXene. Furthermore, the large selectivity coefficient (SU/M > 16.2) declares that Ti3C2-APTES-PA preferentially adsorbs uranium among substantial competing ions. Ti3C2-APTES-PA also shows good cycling performance that its adsorption capacity remained 92.3 % after 6 cycles. When it comes to treating simulated uranium tailings pond leachate and radioactive wastewater from mines, high U(VI) removal rates of 88.9 % and 96.8 % can be achieved by our ternary composite at a dosage of 0.05 g/L. The underlying adsorption mechanism was unraveled by spectroscopic analysis to be the formation of coordination complexes of uranyl ions with phosphate groups on PA and hydroxyl groups on Ti3C2Tx substrate, as well as the reduction of a small amount of adsorbed U(VI) to U(IV) by MXene. The overall results imply that Ti3C2-APTES-PA is an effective uranium chelating scavenger for the treatment of environmental radioactive wastewater.