材料科学
薄脆饼
轮廓仪
蚀刻(微加工)
等离子体刻蚀
复合材料
等离子体
表面粗糙度
白光干涉法
干法蚀刻
光电子学
干涉测量
图层(电子)
光学
量子力学
物理
标识
DOI:10.4028/www.scientific.net/msf.556-557.729
摘要
In this initial phase of work, two methods of backside wafer thinning using ICP plasma etching of two-inch SiC substrates have been considered. Plasma processes were optimized for nonbonded and bonded wafers. The non-bonded process was used to etch 250μm thick substrates to a final thickness of 100μm. The bonded process was used to etch glass bonded SiC substrates mechanically ground to 130μm thick and plasma etched to a final thickness of 100μm. Etch rate measurements and surface analysis were performed using a profilometer and white light interferometry. Etch rates of 3.4μm/min were achieved for the bonded process and 2.0μm/min for the non-bonded process. The surface morphology for the non-bonded process was three to four times lower than the bonded process. The part mechanically ground samples showed evidence of surface damage from the grinding process after plasma etching.
科研通智能强力驱动
Strongly Powered by AbleSci AI