Designing Stainless Steel Reflector at VR-1 Training Reactor

Light-water reactor cores are commonly surrounded by a stainless steel and water reflector. The reflectors are improving power distribution in the core, reducing the leakage of neutrons and thus also protecting the pressurized vessel from the neutron irradiation and the following embrittlement. Contrary to the standard procedures utilized for generation of the fuel assembly data, the reflector elements require a special approach. The major difficulty with the reflectors is represented by an absence of neutron sources in the reflector elements. Some artificial neutron source simulating the realistic source of neutrons from neutron leakage from the surrounding fuel assemblies must be added in the calculation model. The reflector data in the full-core calculations have a great impact on the power distribution in the core. The research in this field is usually focused on the square geometry, and therefore the accurate data for the hexagonal geometry are lacking. Improvements in this area are needed. Training Reactor VR-1 is used for measurements related to nuclear engineering. Department of Nuclear Reactors operating this reactor at the Czech Technical University in Prague is currently designing reflector elements containing stainless steel in order to provide measurable characteristics that can be compared to calculations realized by either Monte-Carlo codes or macroscopic core simulators. This article summarizes the methodology of development of the reflector assemblies to improve their similarity with the VVER-1000 reflector. The impact of the evaluated nuclear data is assessed. Further improvements of the proposed design is necessary to reach better agreement with the neutron spectrum in VVER-1000 reactor reflectors. The influence of evaluated data on the global characteristics was found negligible.