高温电解
聚合物电解质膜电解
电解
材料科学
电力转天然气
制氢
氧化物
化学工程
电化学
碱性水电解
电解水
氢
电极
化学能
蒸汽重整
高压电解
电解槽
固体氧化物燃料电池
可再生能源
氢燃料
无机化学
耐久性
工作温度
功率密度
能量转换
氢经济
分解水
克拉克电极
作者
Freddy Kukk,Sergii Pylypko,Martin Skov Skjoth‐Rasmussen,Enn Lust,Gunnar Nurk
标识
DOI:10.1149/1945-7111/ae1417
摘要
Green hydrogen produced via electrolysis using power from renewables is a key contributor to achieving global climate targets in the chemical industry and energy sector. High-temperature electrolyzers based on solid oxide cells (SOC) offer higher electrical efficiency than alternative electrolyzer technologies, but so far, their capital cost and degradation rates are too high for broad commercial deployment. Therefore, research to increase solid oxide electrolysis cell (SOEC) performance and long-term durability is essential for achieving commercial success. This work aims to improve a commercially produced solid oxide cell by modifying the Ni-8YSZ (yttria stabilized zirconia) hydrogen electrode active layer (HEAL) with iron, cobalt, and gadolinia-doped ceria. Feed gas steam concentration and operating temperatures were varied to study the effect of the promoted materials on SOEC performance under different operating conditions. At 700 °C operating temperature, the modifications of Ni-YSZ with Co, Fe, or GDC led to a decrease of electrochemical performance; however, at 800 °C and at steam concentrations higher than 45% significant improvement of performance was observed. The best results were obtained using the SOC modified with Fe and operated at 800 °C in 90% steam concentration, where a current density of −3.7 A cm −2 was achieved at −1.4 V.
科研通智能强力驱动
Strongly Powered by AbleSci AI