Orthogonal single-mode helical Bragg gratings created in fiber cladding for vector bending measurement

We demonstrate a novel, to the best of our knowledge, two-dimensional vector bending sensor based on orthogonal helical Bragg gratings inscribed in the cladding of a conventional single-mode fiber (SMF). The helical cladding fiber Bragg gratings (HCFBGs) are created by using a femtosecond laser direct writing technology and a quarter-pitch graded index fiber (GIF) is used in front of the HCFBGs to diverge the core mode into fiber cladding. In contrast to the multimode resonance observed in conventional cladding Bragg gratings inscribed by using a femtosecond laser point-by-point (PbP) or line-by-line (LbL) technology, the proposed HCFBGs exhibit stable narrowband single-mode Bragg resonance. An HCFBG with a low peak reflectivity of −50.77 dB and a narrow bandwidth of 0.66 nm was successfully fabricated by using a lateral offset of 45 µm between the HCFBG and the fiber core axis. Moreover, two orthogonal HCFBGs were fabricated in the SMF cladding and used for vector bending sensing. Strong orientation dependence could be seen in omnidirectional bending measurement, exhibiting a maximum bending sensitivity of up to 50.0 pm/m −1 , which is comparable to that in a multicore FBG. In addition, both the orientation and amplitude of bending vector could be reconstructed by using the measured Bragg wavelength shifts in two orthogonal HCFBGs. As such, the proposed HCFBGs could be used in many applications, such as structural health monitoring, robotic arms, and medical instruments.