Temporal and spatial variability in root reinforcement of streambanks: Accounting for soil shear strength and moisture

Riparian vegetation exerts a number of mechanical and hydrologic controls on bank stability, which can affect the delivery of sediment to channels. Estimates of root reinforcement of soils have commonly been attained using perpendicular root models that simply sum root tensile strengths and consider these as an add-on factor to soil strength. A major limitation of such perpendicular models is that tensile strength and resistance is wrongly considered to be independent of soil type and moisture, and therefore variations according to these bank properties are omitted in conventional models. In reality, during mass failure of a streambank, some roots break, and some roots are pulled out of the soil intact; the relative proportions of roots that break or pull out are determined by a combination of soil moisture and shear strength. In this paper an equation to predict the frictional resistance of root–soil bonds was tested against field data collected at Long Creek, MS, under two soil moisture conditions. The root pullout equations were then included in the root-reinforcement model, RipRoot, and bank stability model runs for Goodwin Creek, MS, were carried out in order to examine the effects of spatial and temporal variations in soil shear strength and rooting density, on streambank factor of safety. Model results showed that at smaller root diameters breaking forces exceeded pullout forces, but at larger root diameters pullout forces exceed breaking forces. The threshold diameter between root pullout and root breaking varied with soil shear strength, with increasing soil shear strength leading to a greater proportion of roots failing by breaking instead of pullout. Root-reinforcement estimates were shown to reflect changes in soil shear strength, for example, brought about by variations in soil matric suction. Resulting Factor of safety (FS) values for the bank during the period modeled ranged from 1.36 to 1.74 with 1000 grass roots/m2, compared to a range of 0.97 to 1.37 for the non-vegetated bank. Root reinforcement was shown to increase bank stability under the entire range of soil moisture conditions modeled. However, the magnitude of root reinforcement varied in both space and time as determined by soil shear strength and soil moisture.