机械加工
人工神经网络
材料科学
图表
机械工程
结构工程
计算机科学
冶金
工程类
人工智能
数据库
作者
Monika Kulisz,Ireneusz Zagórski,Andrzej Weremczuk,Rafał Rusinek,Jarosław Korpysa
标识
DOI:10.1007/s43452-021-00319-y
摘要
Abstract This paper presents the results of experimental study of the AZ31 magnesium alloy milling process. Dry milling was carried out under high-speed machining conditions. First, a stability lobe diagram was determined using CutPro software. Next, experimental studies were carried out to verify the stability lobe diagram. The tests were carried out for different feed per tooth and cutting speed values using two types of tools. During the experimental investigations, cutting forces in three directions were recorded. The obtained time series were subjected to general analysis and analysis using composite multiscale entropy. Modelling and prediction were performed using Statistica Neural Network software, in which two types of neural networks were applied: multi-layered perceptron and radial basis function. It was observed that milling with high cutting speed values allows for component values of cutting force to be lowered as a result of the transition into the high-speed machining conditions range. In most cases, the highest values for the analysed parameters were recorded for the component F x , whereas the lowest were recorded for F y . Additionally, the paper shows that a prediction (with the use of artificial neural networks) of the components of cutting force can be made, both for the amplitudes of components of cutting force F amp and for root mean square F rms .
科研通智能强力驱动
Strongly Powered by AbleSci AI