Experimental Evaluation of After-Treatment Solutions for Heavy-Duty Natural Gas Vehicles to Meet Future CNVII Regulations

The heavy-duty truck market in China has seen a significant increase in the adoption of natural gas-powered engines over the past two years. Simultaneously, the anticipated release of the China VII emissions regulation proposal by the end of 2025 is expected to impose stricter emissions limits on all heavy-duty engines, including new particulate number (PN10) thresholds analogous to those in the Euro 7 regulation. While tailpipe oxides of nitrogen (NOx) and methane (CH4) emissions from natural gas engines can be mitigated through tighter lambda control and adjustments to catalyst volume and precious metal (PGM) loading, addressing NOx and particulate number (PN) emissions necessitate more advanced after-treatment solutions. Although natural gas combustion is virtually soot-free, the entrainment of lubricating oil into the combustion chamber, especially during cold-start conditions, poses a challenge, leading to potential exceedance of the proposed future China VII limits. Additionally, PN emissions from natural gas vehicles are highly dependent on duty-cycles and the state of the actual engine, with applications involving frequent stop/go operation experiencing increased piston ring wear, and thus, higher oil consumption, and elevated PN emissions. This study aimed to evaluate the performance of different after-treatment solutions for natural gas engines in meeting future China VII emissions standards, with a particular focus on the efficacy of particle filters for controlling PN10 emissions. Three different after-treatment configurations, comprising close-coupled and underfloor three-way catalysts, as well as bare and coated filters, were tested on a 15L China VI commercial natural gas engine in a controlled laboratory environment. Emissions and PN10 data were collected over regulatory cold and hot World Harmonized Transient Cycle (WHTC) test cycles, and analyzed for light-off behavior, conversion efficiencies, system pressure drop, and filtration effectiveness for particles as small as 10nm. The relative advantages and challenges of each configuration are discussed. The results indicate that natural gas engines will likely require the integration of particle filter devices to comply with future China VII PN10 limits. The results also show that NOx compliance is challenging and fine-tuning of the lambda calibration is essential for CNVII.