材料科学
压阻效应
制作
接口(物质)
纳米技术
造型(装饰)
灵敏度(控制系统)
耐久性
热塑性塑料
导电体
微观结构
信号(编程语言)
响应时间
碳纳米管
可穿戴计算机
弹性体
压缩(物理)
光电子学
可穿戴技术
纳米传感器
微电子机械系统
变形(气象学)
挤压
复合材料
微型多孔材料
电容感应
蚀刻(微加工)
作者
Rui Tong,Kai Xiong,Weilong Zhou,Kang Zhou,Yu Lei Du,Jiabao Lu,Heng Xie,Ting Wu,Jinping Qu
标识
DOI:10.1016/j.aiepr.2025.09.004
摘要
Flexible piezoresistive sensors are pivotal for next-generation wearable electronics, yet are fundamentally constrained by the sensitivity-range-stability trade-off inherent in conventional monoscale architectures. Herein, an efficient method that combines extrusion compression molding and sacrificial templating is proposed for the large-scale fabrication of the dual-microstructured thermoplastic elastomer (TPE)/carbon nanotubes (CNTs) sensor (MTCS). Through synergistic coordination between surface micropillar arrays and interface micropores, the MTCS achieves a 200 kPa detection range and sensitivity of up to 2.324 kPa −1 . At the same time, the sensor exhibits minimal signal degradation following 2000 compression cycles and demonstrates a response time of 146 ms. The micropillar/micropore coordination enables dynamic reconstruction of conductive networks during compression. Micropore collapse enhances through-threshold conduction while micropillar deformation enlarges surface contact area. The MTCS achieves a balanced optimization of sensitivity, detection range, and stability while possessing the advantage of large-scale manufacturing, with performance sufficient to meet demands in scenarios like routine human motion monitoring. The proposed strategy offers a promising approach for advancing the development of flexible piezoresistive sensors.
科研通智能强力驱动
Strongly Powered by AbleSci AI