作者
Ming Chen,Xingyu Hu,Tiankui Guo,Yongzan Liu,Shujie An,Linsen Zhan
摘要
Summary Distributed fiber-optic strain recorded in offset wells after the fracture intersects the fiber (post-hit strain) provides useful information about fracture geometry. However, simultaneously inverting fracture geometry parameters such as fracture height and width in real time from strain recorded in adjacent horizontal monitor wells remains a major challenge. To address this challenge, exploiting the plane-strain nature of the fracture-induced strain after post-hit, a nonlinear inversion model is built upon the Sneddon plane-strain analytical solution. The model is solved by the Levenberg-Marquardt (L-M) algorithm combined with a multistart strategy and Markov Chain Monte Carlo (MCMC) method to achieve global optimization. Using synthetic strain data with added measurement error, the accuracy and uncertainty of simultaneously inverting net pressure, fracture height, and fracture width are systematically analyzed. The inversion accuracy and computational efficiency of three forward models—single-element, multi-element discrete 2D displacement discontinuity method (2D DDM), and the Sneddon analytical solution—are compared, and the applicability of the plane-strain and constant-pressure assumptions is evaluated. Finally, the method is applied to field data from the Hydraulic Fracturing Test Site-2 (HFTS-2) in the United States. The results show that, with the analytical forward model, both L-M and MCMC complete an inversion within seconds, enabling real-time inversion for field monitoring data. Under sufficient near-field and far-field strain data and plane-strain conditions, the analytical-model-based inversion method can simultaneously and accurately invert the net pressure, fracture height, fracture width, with strong robustness to noise types and magnitudes. The asymmetric offset can hardly be reliably resolved from single-fiber strain of the horizontal monitoring well alone. Young’s modulus E only affects the inversion result of net pressure. The inversion using the single-element DDM model yields low accuracy, while the multi-element discrete 2D DDM model is computationally expensive. When fracture height approaches or equals fracture length, the plane-strain assumption is largely violated, leading to insufficient accuracy; when the net pressure is nonuniform, the inversion still provides reasonable estimates of net pressure, fracture height, and width. The synthetic and field tests together confirm that the proposed method offers a feasible and efficient route to quantitative interpretation of net pressure, fracture height, and fracture width from post-hit fiber-optic strain.