Effect of Stabilization Treatment on Size and Properties of Austempered M50 Steel

By using SU‐8010 thermal field scanning electron microscope, JEM‐2100 transmission electron microscope, MHRS‐150 Rockwell hardness tester and X‐ray diffractometer to observe the microstructure and detect residual stress, and the measurement of the hardness and the tensile properties, the effect of stabilization treatment on the microstructure, size change, and mechanical properties of the austempered M50 steel is studied. Results show that the residue of austenite and the carbides precipitated during the bainite transformation after austempering lead to lattice shrinkage, which reduces the size of the bearing ring. The release of quenching stress after tempering increases the size. During austempering and tempering, the size fluctuates between −0.29 and 0.23 mm. After the bearing ring is stabilized for 3 times, the precipitation of filamentous carbides reaches the maximum, and the number of carbides does not increase obviously after 5 times of stabilization. The size fluctuation range is −0.9 to 0.7 μm. After M50 steel is stabilized, the transformation of residual austenite to martensite and the precipitation of carbides increase the hardness, and the coarsening of carbides reduces the ductility. The tensile strength increases from 2550 to 2650 MPa, which is related to the dispersion strengthening of carbides and their pinning effect on dislocations.