Development of toughened and heat-resistant biodegradable injection-molded polylactide acid-based blend foams via enhancing interfacial bonding and PLA phase crystallization

Polylactic acid (PLA) foam is gaining increased attention as a biodegradable alternative to traditional petroleum-based plastic foams, which pose significant environmental pollution issues post-use. However, its potential application is greatly limited by inherent shortcomings such as brittleness and diminished heat resistance post-melting. Herein, high-performance biodegradable PLA/poly(butylene succinate) (PBS) blend foams with well-defined cell structure, high ductility, and enhanced heat resistance were fabricated using a core-back foam injection molding (FIM) process coupled with a straightforward annealing procedure. To enhance compatibility and tailor the dispersed phase morphology into a more fibrillar structure, an epoxy-functional chain extender (ADR) was incorporated. This addition resulted in a substantial increase in the notched impact strength, elevating it to 7.0 kJ/m2, compared to the mere 1.5 kJ/m2 of unmodified PLA foam. Moreover, with the inclusion of 1.0 phr ADR, the notched impact strength of the foam post-annealing soared to 20.7 kJ/m2, a 13.8-fold enhancement compared to pure PLA foam. The formation of a uniformly distributed and interlocked "shish-kebab" crystal structure in the blend facilitated effective stress transfer and distribution, leading to shear yield in the PLA matrix. Additionally, the heat deflection temperature of the annealed blend foam showed a significant increase significantly to 94.7 °C, in contrast to the mere 55.6 °C of pure PLA foam. This study demonstrates a viable and feasible strategy for preparing fully biodegradable PLA foams with high-toughness and heat resistance.