Inverse Identification of Drucker–Prager Cap Model for Ti-6Al-4V Powder Compaction Considering the Shear Stress State

Numerical simulation is an important method to investigate powder-compacting processes. The Drucker–Prager cap constitutive model is often utilized in the numerical simulation of powder compaction. The model contains a number of parameters and it requires a series of mechanical experiments to determine the parameters. The inverse identification methods are time-saving alternatives, but most procedures use a flat punch during the powder-compacting process. It does not reflect the densification behavior under a shearing stress state. Here, an inverse identification approach for the Drucker–Prager cap model parameters is developed by using a hemispherical punch for the powder-compacting experiment. The error between the numerical and experimental displacement–load curves was minimized to identify the Drucker–Prager cap model of titanium alloy powder. The identified model was then verified by powder-compacting experiments with the flat punch. The displacement–load curves acquired by numerical simulation were compared to the displacement–load curves obtained through experiments. The two curves are found to be in good agreement. Meanwhile, the relative density distribution of the powders is similar to the experimental results.