Usually, a lithium transition metal oxide is used for the cathode and a carbonaceous material for the anode of a lithium-ion cell.Here, we study the performance of hard carbons as anode materials.We made our own carbonaceous materials (or carbons for simplicity) by pyrolyzing epoxy novolac resins (DEN 438), which are highly crosslinked materials.First hardened by phthalic anhydride at 120•‹C for 24 hours, the resins were pyrolyzed in an argon atmosphere at 1000•‹C to form carbons. X-ray Diffraction was used to investigate the structure of the carbons.Different pyrolyzing conditions (heating rate, argon flow rate, etc.) can alter certain features of the X-ray pattern, but in all cases, the (002) peak was broad and weak.The (002) peak was found on a large background due to the presence of single-layer carbon sheets.It is hard to fit the X-ray diffraction pattern of hard carbon.But there is a close connection between the shape of the 002 peak and the microstructure of the carbon.A broader and weaker 002 peak indicates more monolayer microstructure in the material.We defined an empirical parameter R to describe the stacking properties of the carbon layers.Cells with these hard carbons as cathodes and lithium metal as anodes have capacities as high as 570 &g (Lil.sC,& while for graphite, the value is only 372mAhfg (LC6).Therefore, these hard carbons are promising candidates as anode materials for lithium-ion batteries.After carehlly studying several groups of samples, we found that the capacity is negatively correlated to R, that is the capacity is the highest when the 002 peak is the weakest and the monolayer microstmcthre is dominant.The high capacities of these materials indicate a mechanism for lithium insertion different from that of lithium intercalation into graphite.We propose that instead of forming an intercalated phase as in graphite (see figure 1.3.1),lithium atoms are adsorbed on both sides of the single carbon layers due to the monolayer and nanoporous nature of the materials (see figure 1.3.3). List of TablesTable 3.1 CHN Analysis ResultsTable 3.2 X-ray difiaction results, Values of RTable 4.1 Cell information sheet ' Heating rate was O.SoUmin from 300•‹C to 600•‹C and 1 or SoUmin othenvise as indicated.* Argon flow rate were controlled at 45 c.c.lmin, much lower than other samples.LT. LessThan