材料科学
机械加工
复合材料
脆性
变形(气象学)
表面完整性
表面粗糙度
超声波传感器
表面光洁度
石墨
铜
声发射
拓本
有限元法
断裂(地质)
振动
电极
冶金
压力(语言学)
电火花加工
图层(电子)
应力集中
消散
超声波加工
失真(音乐)
表层
抛光
电化学加工
刀具
导电体
作者
Kaiyan Zhang,Xin Li,Ruotong Wang,Xueping Zhang
出处
期刊:ASME 2018 13th International Manufacturing Science and Engineering Conference
日期:2025-06-23
卷期号:: V002T14A012-
标识
DOI:10.1115/msec2025-155601
摘要
Copper graphite electrode sheet (CGES) has been widely utilized as an electrode material due to its excellent electrical conductivity and heat dissipation capabilities. However, it bears challenge to achieve the qualitied surface finish of machined CGES by conventional machining methods due to the mechanical property of copper layer different from that of graphite layer, and also due to the scale effect of CGES with the thickness of 0.2mm or smaller. The typical defects including lamination, cracks, and uneven cross-sections are therefore associated with the machining process of CGES. Additionally, the internal material distortion of copper layer accompanies these defects to deteriorate the machined surface integrity. Ultrasonic Vibration Machining (UVM) is thus selected to acquire much superior surface finish of machined CGES by addressing the scale effect and interlayer deformation mechanisms of brittle and ductile materials. This study aims to provide practical optimization parameters in succeeding the ultrasonic vibration machining of CGES. In this research, Finite Element Method (FEM) is implemented to investigate the plastic deformation and fracture mechanism in the ultrasonic vibration machining of CGES, and experiments were conducted to calibrate the FE-based simulation model within 13% predicted error. It shows that ultrasonic vibration machining is beneficial for reducing cutting forces and improving surface integrity by coordinating the fracture evolution behavior of brittle graphite layer and the internal plastic deformation of ductile copper layers. The stress distribution becomes more uniform under ultrasonic vibration to relieve stress concentration along machining direction. Therefore, UVM is beneficial to the formation of favorable surface finish in the machined CGES. Based on the analysis, the optimal vibration frequency is determined as 80kHz with an amplitude of 20μm. The die clearance should be sufficiently small since increased clearances decrease die’s supporting stiffness, alter ductile-brittle transition behavior and eventually deteriorate machined surface integrity.
科研通智能强力驱动
Strongly Powered by AbleSci AI