Research on CeO2 Activated Carbon Electrode Capacitance Method for Sulfate Removal from Mine Water

Sulfate is a typical characteristic pollutant in mine water. Because of its high concentration and large discharge of mine water, it has become a difficult problem in mineral exploitation. Capacitive deionization (CDI) is an innovative and economical removal technology. There are few reports on the use of CDI to remove SO42− from mine water. In this study, a CeO2 activated carbon electrode with good wettability, excellent electrochemical performance, and suitable pore structure was prepared by the sol-gel method. The application of the CeO2 activated carbon electrode to the capacitive method for treating high SO42− mine water was investigated using simulated wastewater and actual mine water. The study structure shows that CeO2:activated carbon (AC) has the best wettability, the highest specific capacitance, and the lowest electrical conductivity when the mass ratio of CeO2 is 5%. At 100 mg/L, the electrode has the maximum SO42− ion specific adsorption capacity (SAC). At 1 V and 20 mL/min, this value is measured. The electrode has a SAC value of 9.36 mg/g, far higher than the AC electrode’s 4.1 mg/g. The effect of CDI process factors such the voltage, flow rate, and initial concentration was studied to find the best treatment method. SAC retention is 91% after 10 adsorption–desorption cycles, demonstrating outstanding electrode performance. Under the best CDI process (1.4 volts, 30 mL/min), mine water was treated. After 20 cycles of treatment, the concentration of SO42− in mine water decreased from 1170 mg/L to 276.46 mg/L, and the removal rate was 76.37%. This study proved that the CeO2 modified activated carbon electrode capacitance method can effectively remove sulfate ions and other ions from mine water.