清晨好,您是今天最早来到科研通的研友!由于当前在线用户较少,发布求助请尽量完整地填写文献信息,科研通机器人24小时在线,伴您科研之路漫漫前行!

Measuring and Controlling Torsional Vibrations and Stick-Slip in a Viscous-Damped Drillstring Model

作者
Emmanuel Olusegun Omojuwa,Samuel Osisanya,Ramadan Mohammed Ahmed
出处
期刊: 被引量:21
标识
DOI:10.2523/iptc-14241-ms
摘要

Abstract Failure of drillstring components due to torsional stresses are caused by torsional vibrations. This paper investigates the response of the drillstring to torsional vibrations through analysis on an elemental stepped-shaft drillstring model in a damped medium. The paper directs its analysis to the stick-slip motion which is the most common form of torsional vibrations in drillstrings; stick-slip motion is defined as the continuous stopping and release of the bit/BHA due to the irregular downhole rotation prompted by the existing relationship between the frictional torque and the torque applied from the surface to free the bit. The interaction between the wellbore and the drill-bit is identified in this paper as the source of excitation, that is, as the downhole vibratory source; hence, the exciting torque or couple is derived from the resolution of forces and reactions at wellbore-drill-bit contact. The response equations obtained from theories of mechanical vibrations and mathematical principles in this paper are in two forms: the transient state and steady-state responses, which makes this research work different from other similar literatures where only the steady-state response is presented. Computer programs are written and tested with suitable drilling data to solve the response equations, display parameters required for vibration analysis and the graphics of the responses to different forms of excitations are also displayed. In order to achieve further reduction of the oscillations of the drillstring model, a vibration control system is designed, which is a torsional vibrations absorber and its influence on the oscillations of the drillstring was also verified. The results and simulations from computer programs are also presented. In conclusion, recommendations are given based on practical solutions to the problems of vibrations and from the findings of this paper. Introduction Torsional or "stick-slip" vibrations are often regarded as one of the most damaging modes of vibration when drilling with low rotary speeds. "Stick-slip" is caused by irregular downhole rotation that fatigues drill collar connections, damages the bit and reduces rate of penetration (ROP). For a typical drillstring of length 15,000-ft (5000-m), torsional disturbance consists of a travelling torsional pulse that bounces back and forth between the top rotary and the drill bit every few seconds periodically forcing the drill bit to "stick" and "slip" for extended periods at the rock surface. The amplitude of this torsional excitation can be two to four times the target or average angular speed (typically between 30 and 150 RPM) set by the top-drive and this can give rise to enormously destructive fluctuating torques in the drillstring that, once out of control, invariably cause damage to the bit or drill string [1]. Torsional vibrations are recognized at the drill-floor by fluctuations in the power needed to maintain a constant rate of surface rotation [2]. The fatigues (cyclic stresses) imposed on the drillstring lead to the sudden failure of the drillstring components and a few other effects, such as: torsional cycles noted at the surface, cutters with impact damage, reduction in life of the bit [3]. Figure 1 shows a damaged BHA component due to shearing [3], an after-effect of torsional stresses.

科研通智能强力驱动
Strongly Powered by AbleSci AI
科研通是完全免费的文献互助平台,具备全网最快的应助速度,最高的求助完成率。 对每一个文献求助,科研通都将尽心尽力,给求助人一个满意的交代。
实时播报
7秒前
狂野的含烟完成签到 ,获得积分10
13秒前
PDIF-CN2完成签到,获得积分10
16秒前
执着语琴完成签到,获得积分10
23秒前
顺心尔冬完成签到,获得积分10
34秒前
43秒前
49秒前
whuhustwit完成签到,获得积分10
1分钟前
1分钟前
欣心发布了新的文献求助10
1分钟前
明亮的依珊完成签到,获得积分10
1分钟前
1分钟前
n01W97的应助被念姬采纳,获得20
1分钟前
兴奋筮完成签到,获得积分10
1分钟前
1分钟前
余又完成签到 ,获得积分10
1分钟前
科研通AI6.3的应助被RZH采纳,获得10
2分钟前
2分钟前
2分钟前
2分钟前
感动的天德完成签到,获得积分10
2分钟前
清脆的芒果完成签到,获得积分10
2分钟前
lishuhua完成签到 ,获得积分10
2分钟前
2分钟前
2分钟前
nikki完成签到 ,获得积分10
2分钟前
2分钟前
CZLhaust发布了新的文献求助10
2分钟前
CZLhaust发布了新的文献求助10
2分钟前
CZLhaust发布了新的文献求助10
2分钟前
CZLhaust发布了新的文献求助10
2分钟前
CZLhaust发布了新的文献求助10
2分钟前
RZH发布了新的文献求助10
2分钟前
2分钟前
漂亮的又槐完成签到,获得积分10
3分钟前
syvshc的应助被兰斯洛特117采纳,获得10
3分钟前
nav完成签到 ,获得积分10
3分钟前
Lucas的应助被王泰一采纳,获得10
3分钟前
3分钟前
sissiarno完成签到,获得积分0
3分钟前
高分求助中
(应助此贴封号)【重要!!请各用户(尤其是新用户)详细阅读】【科研通的精品贴汇总】 10000
拉伸高分子熔体中缠结行为的模拟和小角中子散射研究 1700
The World Atlas of Wine 9th edition 1000
奈特基础组织学:配套组织病理学(第4版)(Netter's Essential Histology With Correlated Histopathology) 800
John McDowells Bildungstheorie 800
八旗制度の研究 600
plantTFDB 508
热门求助领域 (近24小时)
化学 材料科学 医学 生物 纳米技术 计算机科学 工程类 有机化学 化学工程 生物化学 物理 复合材料 内科学 催化作用 光电子学 人工智能 细胞生物学 无机化学 物理化学 数学
热门帖子
关注 科研通微信公众号,转发送积分 8173225
求助须知:如何正确求助?哪些是违规求助? 9565567
关于积分的说明 21780511
捐赠科研通 7767377
什么是DOI,文献DOI怎么找? 3431542
关于科研通互助平台的介绍 2555750
邀请新用户注册赠送积分活动 2476697