Fully handwritten electrodes on paper substrate using rollerball pen with silver nanoparticle ink, marker pen with carbon nanotube ink and graphite pencil

Herein, a so-called carbon nanotube (CNT) electrode was printed in on a paper substrate using the handwriting technique and carbon nanotube ink in a marker pen to print the working electrode, graphite pencil to print the counter electrode and graphite/silver nanoparticle (AgNP) ink in a rollerball pen to print the quasi-reference electrode. The carbon nanotube electrode was characterized via scanning electron microscopy. The electrode was optimized based on the type of paper, hydrophobic barrier and number of layers. In summary, the optimized parameters included the use of matte paper with a mineral spirit layer. The number of carbon nanotube layers to achieve the best electrochemical performance was 25. The final graphite electrode was a miniaturized and flexible paper-based electrochemical electrode. To evaluate the electrical properties of the electrodes, the ohmic resistance of each ink was tested using a multimeter and the obtained values were 18.62 kΩ for the CNT ink, 1.53 Ω for the AgNP ink and 3.53 kΩ for the graphite trace. These results indicate the good conductivity of each synthesized ink used in the fabrication of the CNT electrode. Finally, the electrode was used to measure the electrochemical response of different concentrations of K4[Fe(CN)6]. Then, a calibration curve was obtained from the voltammograms and linearity was observed in the range of 0.5-3.5 mM. This suggests that the CNT electrode has the potential to be used as an amperometric electrode.