缩进
材料科学
有限元法
极限抗拉强度
冯·米塞斯屈服准则
应变硬化指数
半径
模数
机械
可塑性
流量(数学)
复合材料
结构工程
物理
计算机科学
工程类
计算机安全
作者
Tairui Zhang,Shang Wang,Weiqiang Wang
标识
DOI:10.1177/0309324718754960
摘要
An analytical method based on the extended expanding cavity model was proposed in this study to determine the proof strength R p0.2 and flow properties of materials that obey the Johnson–Cook constitutive model from spherical indentation tests. The introduction of the Johnson–Cook model made the proposed method suitable for the tensile property evaluation of materials not only at room temperature but also at elevated temperatures. The validity of the expanding cavity model was verified through comparisons of von Mises equivalent strain distributions obtained from finite element analyses with the corresponding results from theoretical analysis. From the parameter analysis, it was found that the indentation governing parameter ψ empirical in the empirical method was actually determined by the tangential modulus E p and the hardening exponent n and thus should not be considered as a constant. We also analyzed the unreliability of previous plastic zone radius r p calculation method at large indentation depths (with obvious pileup phenomenon) and put forward a new calculation method of r p based on the force balance. Finite element calculations of spherical indentation tests with tensile properties of Ti6Al4V and AISI 4340 were conducted in this study as substitutes for spherical indentation tests. The load–depth data and r p from finite element calculations were employed in the reverse analysis, the results of which showed that spherical indentation tests can provide the same reliable R p0.2 as tensile tests and even the whole stress–strain curves. Furthermore, the influence of friction and the measuring system strain threshold in the measurement of r p , which may be inevitable in experiments, were also thoroughly discussed in this study, which also helped to verify the robustness of this study.
科研通智能强力驱动
Strongly Powered by AbleSci AI