腐蚀
过热器
材料科学
碱金属
冶金
氯
高温腐蚀
管式炉
锅炉(水暖)
钾
硫酸钠
微观结构
氯化物
钠
化学工程
化学
废物管理
有机化学
工程类
作者
Jianjun He,Weizhou Xiong,Wei Zhang,Wei Li,Kailiang Long
标识
DOI:10.1177/1687814016678163
摘要
Alkali sulfates and chlorides may result in rapid corrosion attack of the materials during the process of biomass-fired power generation. The 9-mm-thick 12Cr1MoV superheater tube in biomass-fired boiler was cut into samples by wire cutting. Hot corrosion behaviors of the materials in molten NaCl–50% KCl, KCl–50% K 2 SO 4 , NaCl–50% Na 2 SO 4 , and Na 2 SO 4 –50% K 2 SO 4 at 923 K were investigated by the weight change kinetics, scanning electron microscopy, as well as energy-dispersive spectroscopy. The weight gain curve was studied by electronic balance after each experiment cycle at 12, 24, 48, and 60 h. Compared to the microstructures of the corrosion surface and cross section of each material, concentrated pores and cracks were observed on the samples in molten NaCl–KCl, indicating that chlorides induce severest corrosion by active oxidation of chlorine in all cases. There is an extensive decrease in corrosion rates when mixing chlorides and sulfates together, where active oxidation was inhibited by the sulfates. It is interesting to note that sodium (Na) is not as active and detrimental as contents of potassium (K) to the corrosion of 12Cr1MoV steels, which results in the slightest corrosion effects by NaCl–Na 2 SO 4 both on the surface and cross section of the specimens. Therefore, appropriate adjustment on the mixtures of chlorides and sulfates helps to improve the corrosion resistance of 12Cr1MoV.
科研通智能强力驱动
Strongly Powered by AbleSci AI