Effects of flux-cored arc welding technology on microstructure and wear resistance of Fe-Cr-C hardfacing alloy

This research presented the effects of flux-cored arc welding (FCAW) with and without preheating, gas-shielding and buffering conditions on the microstructure and wear resistance of Fe-Cr-C hardfacing alloy. The flux-cored wires based on austenitic nickel and Fe-Cr-C alloyed steel were used as buffer and hardfacing layers. The welding quality was inspected by visual test (VT) and penetrant test (PT). The structural characteristics were analyzed by optical microscope (OM), X-ray diffractometer (XRD), and scanning electron microscope with energy dispersive X-ray spectrometer (SEM-EDS). The results exhibited that the preheating, gas-shielding and buffering could improve the quality, dilution and weldability of the hardfacing weld. The structural phase of the hardfacing weld was found in the form of (Fe,Cr)7C3 mixed with martensite-austenite matrix (MA matrix). The buffering could combine the interphase of hardfacing to structural steel base resulting in the reduction of crack and carbide precipitation (Fe3C) at the fusion line from the effect of elemental dilution. The combination of buffer and hardfacing layers affected to crystallite size and fraction ratio of (Fe,Cr)7C3 to MA matrix increasing the elemental diffusions. According to the wear testing results (hardness, impact and abrasion), it was found that the preheating, gas-shielding and buffering FCAW provided an excellent wear resistance of Fe-Cr-C hardfacing alloy due to the present of (Fe,Cr)7C3 eutectic carbide in a high fraction of MA matrix resulting in good toughness-hardness balance properties. In addition, the suitable FCAW condition from the study could be applied for hardfacing of the tooth plate of crushing roller that was used in the biomass energy industry with better service life than traditional FCAW.