Electrode-Resolved Impedance and Potential Measurements to Investigate the Rate Capability of High Loading Micron-Silicon Anodes in All-Solid-State Batteries

硅 材料科学 阳极 电阻抗 电极 光电子学 固态 工程物理 电气工程 化学 工程类 物理化学
作者
Gioele Conforto,Robin Schuster,Moritz Bohn,Tobias Kutsch,Hubert A. Gasteiger
出处
期刊:Meeting abstracts [Institute of Physics]
卷期号:MA2023-02 (2): 401-401
标识
DOI:10.1149/ma2023-022401mtgabs
摘要

In order to enable the market introduction of all-solid-state batteries (ASSBs), several anode concepts are under investigation to increase the energy density compared to graphite anodes, while maintaining long cycle-life. At the same time, the production costs must be the same or even reduced in comparison with classical lithium-ion batteries. Besides lithium metal as anode material, which still poses significant technical challenges, more and more interest is being directed toward materials that form lithium alloys. One of the most attractive candidates is silicon, which has a low delithiation potential of around 0.45 V vs. Li + /Li and an attractive theoretical gravimetric capacity of 3579 mAh/g Si , which in the fully lithiated state corresponds to a volumetric capacity of ≈2190 mAh/cm 3 , even higher than the one reachable by lithium metal. Silicon-containing anodes are already being introduced in classical lithium-ion batteries. For that system, the lithium-ion conduction across the anode electrode is mainly provided by the liquid electrolyte that fills the pores of the electrode, while the electrical conduction is enhanced by the addition of graphite and/or conductive carbon additives, because crystalline silicon is only a semiconductor. As is well known, the major issue with silicon anodes is the volume expansion of 300% upon lithiation of silicon, inducing severe cracking of µm-sized silicon particles as well as continuous solid electrolyte interphase (SEI) growth, both of which lead to a fast capacity fading. The intrinsic solid nature of all-solid-state batteries opens the possibility of a new electrode concept that has the potential to mitigate the above-mentioned drawbacks of silicon. Indeed, the silicon particles themselves could be used for the lithium-ion conduction across the electrode, so that anode electrodes can be prepared that are free of electrolyte, thereby largely restricting SEI formation to the anode/separator interface . In this work, anodes with >90% weight of silicon are prepared by coating a water-based slurry that contains microscale silicon particles (ca. 2-4 µm diameter) as active material, the rest being made up of LiPAA and NaCMC as binders as well as C65 carbon as conductive additive. The combination of the water-based process and the microscale dimension of the silicon particles make this electrode concept easily scalable and cost-effective. To reach a competitive areal silicon anode capacity of 3 mAh/cm 2 , with the full utilization of the silicon, only a thin layer is needed (pristine thickness of 8 µm when the anode porosity is 50%). The thickness variation and the anode morphology are being investigated by examining cross-sectional scanning electron microscopy (SEM) images at different states-of-charge (SOC). After the first complete lithiation, the anode consists of a fully dense and compact Li 3.75 Si alloy block of 15 µm thickness. Upon its complete delithiation, a peculiar porous columnar morphology is formed that on account of the void space between the columns and within the columns retains a thickness of 11 µm. This peculiar morphology was recently reported in the literature (Tan et al. , Science 373 (2021), 1494–1499); and seems to be reversible during subsequent lithiation and delithiation processes. For example, our half-cells utilizing an InLi counter electrode and operating at 70 MPa have more than 80% capacity retention after 350 cycles at a rate of C/5, with an average coulombic efficiency higher than 99.9%. The reason for this promising stability could be attributed to the minimal loss of lithium into the SEI, which is limited to the geometrical contact area between the silicon and the solid electrolyte separator. To better understand the electrochemical and mechanical characteristics of these silicon anodes, they are investigated in full-cells, utilizing an NCM composite cathode, while the anode potential is monitored by using a gold wire micro reference electrode (µ-RE) which was recently developed in our group (Sedlmeier et al ., J. Electrochem. Soc. 170 (2023) 030536). This specific µ-RE, which has a defined and stable potential, allows to precisely deconvolute the potential curves of cathode and anode, and also to measure and separate the impedance contributions of the two electrodes. Therefore, the impedance of the silicon anode is measured at different SOC to understand how the contact resistances, the charge-transfer resistance, and the solid-state diffusion affect its overall impedance. In particular, the low impedance at high SOC enables to reach a good fast charging rate capability up to 1C without lithium metal plating and dendrite formation, as reported in Figure 1. However, in order to explore whether the fast charging goal of 4C (80% of the capacity in 15 minutes) can be reached, the influence of the carbon additive, operating temperature and applied pressure are being investigated. Figure 1

科研通智能强力驱动
Strongly Powered by AbleSci AI
科研通是完全免费的文献互助平台,具备全网最快的应助速度,最高的求助完成率。 对每一个文献求助,科研通都将尽心尽力,给求助人一个满意的交代。
实时播报
lllll完成签到 ,获得积分10
刚刚
2秒前
范yx发布了新的文献求助10
3秒前
Eric完成签到,获得积分10
3秒前
陈烨完成签到,获得积分10
3秒前
侯子完成签到 ,获得积分10
7秒前
shally发布了新的文献求助10
8秒前
ninini完成签到 ,获得积分10
8秒前
En完成签到 ,获得积分10
8秒前
慧慧34完成签到 ,获得积分10
9秒前
回首不再是少年完成签到,获得积分0
12秒前
14秒前
Singularity发布了新的文献求助20
17秒前
chenchen完成签到 ,获得积分10
18秒前
20秒前
含糊的盼波完成签到,获得积分10
21秒前
光亮如容完成签到,获得积分10
25秒前
25秒前
浩浩完成签到 ,获得积分0
28秒前
圆圆完成签到 ,获得积分10
40秒前
chunlily完成签到 ,获得积分10
40秒前
xujiahao完成签到,获得积分10
41秒前
42秒前
黑米粥发布了新的文献求助200
47秒前
47秒前
zw完成签到,获得积分10
48秒前
沉默岩完成签到,获得积分10
52秒前
中恐完成签到,获得积分0
52秒前
JamesPei的应助被shally采纳,获得10
53秒前
肥猫完成签到,获得积分10
57秒前
谦让的忆枫完成签到,获得积分10
57秒前
lll完成签到 ,获得积分10
58秒前
黑米粥发布了新的文献求助200
1分钟前
arniu2008的应助被科研通管家采纳,获得20
1分钟前
arniu2008的应助被科研通管家采纳,获得20
1分钟前
arniu2008的应助被科研通管家采纳,获得20
1分钟前
1分钟前
开心完成签到 ,获得积分10
1分钟前
shally发布了新的文献求助10
1分钟前
Zzy完成签到 ,获得积分10
1分钟前
高分求助中
(应助此贴封号)【重要!!请各用户(尤其是新用户)详细阅读】【科研通的精品贴汇总】 10000
拉伸高分子熔体中缠结行为的模拟和小角中子散射研究 1700
The World Atlas of Wine 9th edition 1000
奈特基础组织学:配套组织病理学(第4版)(Netter's Essential Histology With Correlated Histopathology) 800
八旗制度の研究 600
高分子基功能界面水蒸发材料与应用研究 500
外场增强的水汽发电研究 500
热门求助领域 (近24小时)
化学 材料科学 医学 生物 纳米技术 计算机科学 工程类 有机化学 化学工程 生物化学 物理 复合材料 内科学 催化作用 光电子学 人工智能 细胞生物学 无机化学 物理化学 数学
热门帖子
关注 科研通微信公众号,转发送积分 8185502
求助须知:如何正确求助?哪些是违规求助? 9574220
关于积分的说明 21834553
捐赠科研通 7783121
什么是DOI,文献DOI怎么找? 3434577
关于科研通互助平台的介绍 2558949
邀请新用户注册赠送积分活动 2481357