Decoration of sodium carboxymethylcellulose gel microspheres with modified lignin to enhanced methylene blue removal

The introduction of active groups from biomass is currently the most promising alternative method for increasing the adsorption effect of dyes. In this study, modified aminated lignin (MAL) rich in phenolic hydroxyl and amine groups was prepared by amination and catalytic grafting. The factors influencing the modification conditions of the content of amine and phenolic hydroxyl groups were explored. Chemical structural analysis results confirmed that MAL was successfully prepared using a two-step method. The content of phenolic hydroxyl groups in MAL significantly increased to 1.46 mmol/g. MAL/sodium carboxymethylcellulose (NaCMC) gel microspheres (MCGM) with enhanced methylene blue (MB) adsorption capacity owing to the formation of a composite with MAL were synthesized by a sol-gel process followed by freeze-drying and using multivalent cations Al3+ as cross-linking agents. In addition, the effects of the MAL to NaCMC mass ratio, time, concentration, and pH on the adsorption of MB were explored. Benefiting from a sufficient number of active sites, MCGM exhibited an ultrahigh adsorption capacity for MB removal, and the maximum adsorption capacity was 118.30 mg/g. These results demonstrated the potential of MCGM for wastewater treatment applications.