接触角
表面改性
材料科学
稻草
复合材料
表面能
表面粗糙度
胶粘剂
蜡
介质阻挡放电
水蒸气
复合数
化学工程
电介质
化学
图层(电子)
有机化学
光电子学
工程类
无机化学
作者
Weimin Chen,Yicheng Xu,Shukai Shi,Yizhong Cao,Minzhi Chen,Xiaoyan Zhou
标识
DOI:10.1038/s41598-018-20285-5
摘要
The presence of non-poplar extracts, cutin, and wax layer in the wheat straw outer surface (WOS) greatly limit its application in bio-composite preparation. In this study, a dielectric-barrier-discharge plasma using water vapor as feeding gas was used to fast modify the WOS. The morphology, free radical concentrations, surface chemical components, and contact angles of WOS before and after plasma modification were investigated. Wheat straw was further prepared into wheat straw-based composites (WSC) and its bonding strength was evaluated by a paper tension meter. The results showed that water vapor plasma leads to the appearance of surface roughness, the generation of massive free radicals, and the introduction of oxygen-containing groups. In addition, both initial and equilibrium contact angle and the surface total free energy were significantly increased after plasma modification. These results synergistically facilitate the spread and permeation of adhesive onto the WOS and thus improve the bonding strength of all prepared WSCs. A good linear relationship between bonding strength and surface roughness parameters, contact angles, and total free energy were observed. In general, this study provided a time-saving and cost-effective modification method to realize WSC manufacture.
科研通智能强力驱动
Strongly Powered by AbleSci AI