Post-fire soil greenhouse gas fluxes in boreal Scots pine forests–Are they affected by surface fires with different severities?

Although forest fires are one of the main natural disturbance types in boreal forests, there is limited information regarding surface fires (dominant in Northern Europe), and how surface fires of different severities could affect post-fire soil greenhouse gas emissions. The results of our study show that fire severity, time since fire and post-fire changes in soil temperature were the main factors driving soil carbon dioxide (CO2) flux (forest floor ecosystem respiration) from burned boreal forest soils. Approximately two hours after the fire, soil CO2 emissions from burned areas were significantly higher compared to pre-fire conditions, and areas with high-severity fires had significantly higher soil CO2 emissions compared to those with low-severity fires. Later (days, months) after the fire, the unburned control areas always had higher soil CO2 emission values compared to burned areas. In the case of methane (CH4), time since fire and post-fire changes in soil temperatures were the main factors driving soil CH4 fluxes. Unburned study areas were sinks of CH4 through the entire measurement period, while immediately after the fire, the burned areas turned from CH4 sink to CH4 source. For nitrous oxide (N2O) measurements, time since fire was the only factor that significantly affected soil N2O fluxes. Shortly after the fire, N2O emissions increased significantly from both low- and high-intensity study plots. Two days after the fire, post-fire soil C and N content decreased in the O-horizon and increased within the first 5 cm of the soil mineral layer, and the trend was visible both in low- and high-severity fire plots. Samples collected four months after the fire, showed similar total soil C and N content as there was before the fire.