Research on the preparation and properties of GBFS-based mud solidification materials

Various problems are often encountered during the backfilling process of deep foundation pits. The development of low-cost and efficient solidified materials for the preparation of fluidized solidified soil is currently an ideal solution. This article used industrial solid waste (granulated blast furnace slag, fly ash, carbide slag, etc.) as the main raw material to study the hydration hardening properties of solidified materials and the construction feasibility of fluidized solidified soil prepared from solid waste materials. The results are as follows: Compared with cement-based materials, solid waste-based solidified materials had lower early activity. The cumulative heat release within 72 h was less than 200 J/g. Different solid wastes, such as fly ash and carbide slag, had different effects on the properties of solidified materials. Overall, they had the potential to prepare fluidized solidified soil. The prepared fluidized solidified soil had a fluidity greater than 350 mm, a 28d compressive strength greater than 3 MPa, and exhibited good workability and excellent mechanical properties. Hydration products such as C-S-H and AFt were filled in the soil structure. The 28d compressive strength well above the design requirements of general engineering projects. Meanwhile, the prepared fluidized solidified soil had good adaptability to conventional water reducers (fluidity could be increased by more than 40%) and early strength agents (1d compressive strength could be increased by more than 60%).