Regulating mechanical performance of poly (l-lactide acid) stent by the combined effects of heat and aqueous media

Annealing process has been applied to the development of thermoforming polymer braided stent and treating its basic constitute monofilaments, especially for Poly (l-lactide acid) (PLLA) condensed by lactic acid monomer made from the plant starch. In this work, high performance monofilaments were produced by melting spun and solid-state drawing methods. Inspired by the effects of water plasticization on semi-crystal polymer, PLLA monofilaments were annealed with and without constraint in vacuum and aqueous media. Then, the co-effects of water infestation and heat on the micro-structure and mechanical properties of these filaments were characterized. Furtherly, mechanical performance of PLLA braided stents shaped by different annealing methods was also compared. Results showed that annealing in aqueous media generated more obvious structure change of PLLA filaments. Interestingly, the combined effects of aqueous phase and thermal effectively increased the crystallinity, and decreased the molecular weight and orientation of PLLA filaments. Therefore, higher modulus, smaller strength, and elongation at the break for filaments could be obtained, which could furtherly realize better radial compression resistance of the braided stent. This annealing strategy could provide new perspectives between anneal and material properties of PLLA monofilaments, and provide more suitable manufacturing technics for polymer braided stent.