Calibration of a Miniature Cone Penetrometer for Highway Applications

The electronic cone penetrometer is an important in situ investigation tool of choice for site characterization. Application of this proven concept of the cone penetration test (CPT) to highway design and construction control by miniaturization is described. A miniature cone penetrometer with a projected cone area of 2 cm 2 has been developed and implemented in a continuous intrusion miniature cone penetration test system (CIMCPT). This device may be used for rapid, accurate, and economical characterization of sites and to determine engineering soil parameters needed in the design of pavements, embankments, and earth structures. The miniature cone penetration test (MCPT) gives finer details than the standard 10-cm 2 cross-sectional area reference cone penetrometer. This makes the MCPT attractive for subgrade characterization, quality-control assessment, compaction control of embankments, and assessment of ground improvement effectiveness for transportation infrastructure. In situ calibration of the CIMCPT system was conducted at a highway embankment site in Baton Rouge, Louisiana. MCPT penetration profiles were compared with those obtained by using the standard cone penetrometer at the same site. The tip resistance of the MCPT was 10 percent higher than that of the reference CPT. The sleeve friction and friction ratio of the reference CPT were higher than that of the MCPT by 12 and 23 percent, respectively. Calibration was also performed to determine empirical cone factors required for estimating undrained shear strength from MCPT data.