Study on Demulsification Pre-Treatment of Emulsified Wastewater

In this paper, the flocculation effect of single flocculants and compound flocculants on emulsified wastewater under different conditions was studied. The effect of flocculant type, dose, settling time and composite ratio of flocculant on the treatment of emulsified wastewater were investigated through single-factor condition tests, and then the optimal conditions of flocculants for treating emulsified wastewater were obtained. The results showed that the single inorganic flocculant could break the stable state of the emulsion when the pH was adjusted to 7 and formed tiny flocs, but it took a long time to settle down. The single organic flocculant had no flocculation effect. The inorganic–organic composite flocculants could effectively solve the problem of emulsion breaking and flocculation, and could form large flocs and alum flower formations at the same time, with mud and water effectively separated. The best conditions for the composite flocculants were as follows: under the condition of room temperature and pH 7, the dose of PFC was 2250 mg/L and APAM was 5 mg, the homogeneous stirring time was 10 min, and the settling time was 0.5 h. The removal rate of COD and turbidity reached 84.75% and 99.86%. The study could provide a new treatment idea and method for the pretreatment of stabilized high-turbidity wastewater.