材料科学
电子背散射衍射
各向异性
极限抗拉强度
残余应力
纹理(宇宙学)
复合材料
多孔性
拉伸试验
衍射
中子衍射
可塑性
微观结构
光学
图像(数学)
物理
人工智能
计算机科学
作者
Amir Charmi,Rainer Falkenberg,Luis Alexander Ávila Calderón,Gunther Mohr,Konstantin Sommer,Alexander Ulbricht,Maximilian Sprengel,Romeo Saliwan Neumann,Birgit Skrotzki,Alexander Dominic Evans
标识
DOI:10.1016/j.msea.2020.140154
摘要
The underlying cause of mechanical anisotropy in additively manufactured (AM) parts is not yet fully understood and has been attributed to several different factors like microstructural defects, residual stresses, melt pool boundaries, crystallographic and morphological textures. To better understand the main contributing factor to the mechanical anisotropy of AM stainless steel 316L, bulk specimens were fabricated via laser powder bed fusion (LPBF). Tensile specimens were machined from these AM bulk materials for three different inclinations: 0°, 45°, and 90° relative to the build plate. Dynamic Young’s modulus measurements and tensile tests were used to determine the mechanical anisotropy. Some tensile specimens were also subjected to residual stress measurement via neutron diffraction, porosity determination with X-ray micro-computed tomography (μCT), and texture analysis with electron backscatter diffraction (EBSD). These investigations revealed that the specimens exhibited near full density and the detected defects were spherical. Furthermore, the residual stresses in the loading direction were between −74±24MPa and 137±20MPa, and the EBSD measurements showed a preferential 〈110〉 orientation parallel to the build direction. A crystal plasticity model was used to analyze the elastic anisotropy and the anisotropic yield behavior of the AM specimens, and it was able to capture and predict the experimental behavior accurately. Overall, it was shown that the mechanical anisotropy of the tested specimens was mainly influenced by the crystallographic texture.
科研通智能强力驱动
Strongly Powered by AbleSci AI