缓冲放大器
共栅
电压
CMOS芯片
电子线路
电子工程
输出阻抗
总谐波失真
电气工程
电源抑制比
共模信号
放大器
工程类
计算机科学
模拟信号
数字信号处理
作者
Marius Neag,István Z. Kovács,Raul Oneţ,Iulian Câmpanu
出处
期刊:
日期:2021-05-28
卷期号:114: 105115-105115
被引量:5
标识
DOI:10.1016/j.mejo.2021.105115
摘要
This paper presents several options for the design of OA-based highly linear fully differential voltage buffers able to drive heavy loads at frequencies in the tens of MHz range. The buffer is first implemented by using a telescopic OA with enlarged voltage swing; two circuits for controlling the common mode level of the output voltage are proposed. Next, two implementations based on the folded cascode transconductor with a Monticelli-type complementary source-followers second stage are presented. One of them uses complementary source followers embedded into the Monticelli gain stage, in order to lower the buffer output impedance. The proposed circuits have been implemented in a standard 0.35 μm CMOS technology as design options for a voltage buffer required by a downhole sensor used in geological surveys. There, they have to drive a standard one-OA difference amplifier which presents heavy, unbalanced loads to their positive and negative outputs, respectively 1.5 kΩ and 500Ω. Simulation results validate the designs, demonstrating that all four circuits meet the requirements: they handle sine voltages with amplitudes up to 2VPPDIFF at frequencies up to 100 MHz, with THD values better than 0.4% for signals in the tens of MHz range, achieving CMRR and PSRR values above 40 dB at 100 MHz, while consuming between 5.3 mA and 8.3 mA from a 3.3V supply.
科研通智能强力驱动
Strongly Powered by AbleSci AI