流量(数学)
墨盒
粒子群优化
体积热力学
频道(广播)
管道(软件)
材料科学
工程类
工作(物理)
流量系数
液压头
水力直径
优化设计
计算机科学
摩擦损失
流动条件
机械工程
气门座
机械
管道运输
压力调节器
压力降
背压
压头
电液伺服阀
水力机械
切线
控制理论(社会学)
作者
Chunqiang Jia,Ma Wenyu,Zhang Chengshuai,Yao Dongliang
标识
DOI:10.1177/09544062261444245
摘要
This study proposes an optimization design method for parallel flow channels in hydraulic cartridge valve blocks manufactured via additive manufacturing (AM), with the dual objectives of minimizing pressure loss and pipeline length. Based on the structural characteristics of parallel flow channels, optimization models for both direct and deviated configurations were developed. Using computational fluid dynamics (CFD) simulations, fitting equations relating structural parameters to pressure loss were established. A response particle swarm optimization (RPSO) algorithm was then applied to optimize the flow channel design, and the reliability of the optimization results was verified experimentally. The results indicate that, for direct-connected flow channels, pressure loss is minimized when the main flow axis is tangent to the valve chamber; under this condition, the volume of an 8 mm diameter flow channel was reduced by 25.84%, and the pressure loss decreased by 3.97%. For the optimized deviated flow channel, the volume was reduced by 8.4%, and the pressure loss decreased by 10.58%. This work provides an effective optimization approach for the design of parallel flow channels in additively manufactured hydraulic valve blocks, laying a foundation for further development and application of AM-based hydraulic systems.
科研通智能强力驱动
Strongly Powered by AbleSci AI