Effects of Heat Treatment on Microstructure and Mechanical Properties of a Transformation-Induced Plasticity-Aided Economical Duplex Stainless Steel

In order to obtain steel with high tensile strength and elongation and good pitting resistance, the economical duplex stainless steel with and without the addition of tungsten (W) was prepared in this paper. The comparison and distribution of the two phases were controlled by optimizing the heat treatment process. The highest product of tensile strength and elongation of Cr19 series duplex stainless steel (DSS) DSS were obtained after solution treatment at 1050 °C for 5 min, up to 58692 Mpa%(876 Mpa * 67%), when the area f.raction of α was about 50.7%. The addition of tungsten reduces tensile strength due to the increased area fraction of α at 1050–1150 °C. Finer grain size leads to higher tensile strength after solution treatment at 1050 °C. The microstructure is characterized by transmission electron microscopy (TEM) and electron backscatter diffraction (EBSD). The steels exhibit an excellent transformation-induced plasticity (TRIP) effect after the solution treated is at 1050 °C, which may primarily be due to the existence of a more unstable austenite phase. The TRIP effect acts through the phase transformation of γ to α′-M during high deformation, and the orientation relationship of {111}γ || {110}α′-M & <110>γ || <001>α′-M belongs to the standard variants of Nishiyama–Wassermann relationship.