Effects of Exercise Sequence and Velocity Loss Threshold During Resistance Training on Following Endurance and Strength Performance During Concurrent Training

PURPOSE: This study aimed to analyze the response to 4 concurrent training interventions differing in the training sequence and in the velocity loss (VL) threshold during strength training (20% vs 40%) on following endurance and strength performance. METHODS: A randomized crossover research design was used. Sixteen trained men performed 4 training interventions consisting of endurance training (ET) followed by resistance training (RT), with 20% and 40% VL, respectively (ET + RT20 and ET + RT40), and RT with 20% and 40% VL, respectively, followed by ET (RT20 + ET and RT40 + ET). The ET consisted of running for 10 minutes at 90% of maximal aerobic velocity. The RT consisted of 3 squat sets with 60% of 1-repetition maximum. A 5-minute rest was given between exercises. The oxygen uptake throughout the ET and repetition velocity during RT were recorded. The blood lactate concentration, vertical jump, and squat velocity were measured at preexercise and after the endurance and strength exercises. RESULTS: The RT40 + ET protocol showed an impaired running time along with higher ventilatory equivalents compared with those protocols that performed the ET without previous fatigue. No significant differences were observed in the repetitions per set performed for a given VL threshold, regardless of the exercise sequence. The protocols consisting of 40%VL induced greater reductions in jump height and squat velocity, along with elevated blood lactate concentration. CONCLUSIONS: A high VL magnitude (40%VL) induced higher metabolic and mechanical stress, as well as greater residual fatigue, on the following ET performance.