电渗析
锂同位素
同位素分离
锂(药物)
化学
离子键合
离子
分析化学(期刊)
同位素
放射化学
无机化学
离子交换
膜
核物理学
色谱法
物理
医学
内分泌学
有机化学
生物化学
出处
期刊:Meeting abstracts
[Institute of Physics]
日期:2017-09-01
卷期号:MA2017-02 (22): 1025-1025
标识
DOI:10.1149/ma2017-02/22/1025
摘要
Tritium needed as a fuel for fusion reactors is produced via neutron capture by lithium-6 ( 6 Li). However, natural Li contains only about 7.8% 6 Li, and enrichment of 6 Li up to 90% is required for adequate tritium breeding in fusion reactors. The mercury amalgam method is superior to some of the lithium isotope enrichment methods. In Japan, lithium isotope enrichment methods have been developed to avoid the environmental hazards of using mercury. However, the isotope separation coefficient and efficiency is too low to meet the practical need of large mass production of 6 Li. Therefore, new Li isotope separation technique using a Li ionic superconductor functioning as a Li isotope separation membrane (LISM) have been developed [1]. Li ions move by electrodialysis through LISM between the cathode and the anode in lithium solutions. Because the mobility of 6 Li ions is higher than that of 7 Li ions, 6 Li can be enriched on the cathode side of a cell. It has been reported that the difference in the mobility between 6 Li and 7 Li become large in ionic superconductor. The isotope effect in ionic superconductor is expected to be applicable to isotope separation membrane. In this research, we numerically investigated the ionic mobility of Li isotopes in ionic superconductor. Combing the first principle and the kinetics Monte Calro simulation, we calculate the diffusion constant of 6 Li and 7 Li. I show the two important effects for the difference in the mobility between isotope of Li. The first is the quantum effect, which decrease the diffusion barrier for Li ion and increase the ratio of the diffusion constant of Li isotopes. The second is the correlation effect between 6 Li, 7 Li and vacancy. Using Li 0.29 La 0.57 TiO 3 (LLTO) as the Li ionic superconductor was prepared, and the relationship between the 6 Li separation coefficient and the electrodialysis time was investigated. After electrodialysis, we obtained a maximum of 1.04 for the 6 Li isotope separation coefficient. This result showed that the 6 Li isotope separation coefficient of this method is the same as that of the amalgamation process using mercury (1.06). Thus, this method has the potential to be a superior 6 Li enrichment method to produce 90% enriched tritium breeder for fusion reactors. Figure 1
科研通智能强力驱动
Strongly Powered by AbleSci AI