Fabrication of composite hollow fiber membranes with thin film selective layers from highly permeable polymers

Fabrication of highly efficient composite gas separation membranes involves selection and pretreatment of the support material. In the present work, porous support pretreatment was for the first time studied for deposition of thin selective layers made from highly permeable organosilicon polymers. Asymmetric polysulfone hollow fiber membranes with mesoporous skin layer structure were employed as supports. It was shown that preliminary impregnation of the support pores is essential for composite membranes fabrication. If poly[1-(trimethylsilyl)-1-propyne] layers from casting solution are deposited onto the polysulfone support without impregnation, the casting solution penetrates the mesoporous layer to a depth of > 1 μm, thus predominantly (> 90%) contributing the overall mass transfer resistance, as estimated by the resistance-in-series model. Such membranes provide relatively poor transport properties: carbon dioxide permeance is 0.2-0.3 m 3 /(m 2 ·h·bar). Preliminary impregnation of porous support by distilled water or aqueous glycerol solution prevents casting solution penetration into porous support and results in defect-free thin polymer layer. According to SEM, the deposited selective layer thickness is less than 1 μm. Composite membranes fabricated via this technique provide permeance increase more than order of magnitude. The composite membranes with poly[1-(trimethylsilyl)-1-propyne] and polydimethylsiloxane selective layers show high transport properties in gas-liquid membrane contactors.