Experimental Study on the Dynamic Response of Different Grades of Corroded Steel Reinforcement

The mechanical behavior of corroded steel reinforcement under dynamic loadings is crucial for the entire structural response of reinforced concrete elements located in seismic regions. Taking into account the need to assess the structural integrity of existing building stock and the fact that the majority of the existing RC structures in Greece are constructed with the use of steel grades of S400 (equivalent to BSt 420s) and Tempcore B500c, the present study examines the dynamic behavior of rebars of different grades under low cycle fatigue (LCF) at a constant strain amplitude of ±2.5% and compares their performance through a quality material index. In the margin of the current research, the study also included two different grades of hybrid rebars, Tempcore B450 and dual-phase F (DPF). The outcomes demonstrated that single-phase S400 steel underwent mild degradation in its ductility, whereas its bearing capacity was significantly decreased due to corrosion. In contrast, B500c illustrated its superiority in terms of strength, yet recorded extremely limited service life, even in uncorroded conditions, raising questions about its reliability and the structural integrity of existing building stock. However, in corroded conditions, even if B500c corroded rebars showed higher mass loss values than the other examined grades, the degradation of their mechanical behavior due to corrosion was found to be minimal. Furthermore, dual-phase DPF rebars, with their homogeneous microstructure, appeared particularly promising with respect to Tempcore B450 if one considers the span of its service life compared to the extent of corrosion damage.