石墨烯
材料科学
电阻式触摸屏
过程(计算)
激光器
绿光激光器
制造工艺
纳米技术
光电子学
复合材料
计算机科学
工程类
电气工程
光学
物理
操作系统
作者
Rogério Miranda Morais,Douglas Henrique Vieira,Maíza da Silva Ozório,Gabriel Leonardo Nogueira,Andrew Rollo,Jeff Kettle,Neri Alves
标识
DOI:10.1002/adsu.202400166
摘要
Abstract Laser induced graphene (LIG), prepared directly with an in situ synthesis method onto Kraft Paper substrates, is proposed for the manufacture of biodegradable electronic devices. The investigation explores the influence of laser power and scanning speed on the properties of LIG conductive tracks and a sheet resistance of up to 0.25 kΩ sq−1. Raman spectroscopy and microscopy is used to analyse the interfacial properties, in particular the transition of cellulose fibers to carbonized graphene flakes through photothermal pyrolysis, leading to the formation of coral‐like structures. To demonstrate the applicability of the approach, flexible resistive heaters have been manufactured and tests show rapid heating with a homogeneous distribution and a maximum temperature of 145.5 °C. Additionally, an electro‐thermal conversion efficiency (hr+c) of 17.05 mW (°C cm2)−1 is achieved. Finally, a comparative Life Cycle Assessment with FR‐4 based electronics has been undertaken and the environmental impacts are calculated. The impact assessment shows a two magnitude lower impact on the environment for most categories, which suggests the approach is beneficial for the environment at a global production level. The results show that the photothermal pyrolysis of Kraft paper using a laser diode allows for low‐impact devices flexible and green electronics products.
科研通智能强力驱动
Strongly Powered by AbleSci AI