材料科学
奥氏体
晶界
奥氏体不锈钢
粒度
降水
相(物质)
冶金
微观结构
极限抗拉强度
等离子体
分析化学(期刊)
离子
结晶学
复合材料
化学
腐蚀
物理
气象学
有机化学
量子力学
色谱法
作者
Valentina Alexandrovna Moskvina,Elena G. Astafurova,Kamil Nurullaevich Ramazanov,R.S. Esipov,Galina Gennadievna Maier,Sergey Vladimirovich Astafurov,Marina Yu. Panchenko,Реунова Ксения Андреевна,E. V. Melnikov,А. И. Смирнов
标识
DOI:10.1016/j.msea.2021.141777
摘要
Abstract We study the influence of different grain size (density of grain boundaries) on the way of phase transformations in the surface layers of 316 L-type austenitic stainless steel under ion-plasma treatment. Using thermomechanical treatments, we fabricated a series of specimens possessing a single-phase austenitic structure, close density of the defects of the crystal lattice and different grain sizes (fine-grained with d ≈ 3–6 μm and coarse-grained with d ≈ 55 μm). These specimens were subjected to ion-plasma surface treatment at 550 ± 10 °C in N2+C2H2+Ar gases mixture to provoke a precipitation hardening. Although fine-grained and coarse-grained specimens possess similar penetration depth of interstitial atoms (N, C) under ion-plasma treatment (≈40–48 μm), the distribution of interstitials and phase composition are different in them. After ion-plasma treatment, specimens with low density of grain boundaries (coarse-grained structure) maintain a high level of N, C atoms in the solid solution of austenite (a = 0.3653–0.3674 nm) with a strip-like arrangement of Fe4(N,C) particles within grains, while precipitation of Cr(N,C) phase is suppressed. For these specimens, tensile diagrams have the extended linear stages typical of nitrogen-bearing austenitic steels, and the loss of ductility assisted with ion-plasma treatment is the smallest among studied specimens. Ion-plasma treated specimens with high density of grain boundaries (fine-grained structure) are prone to a decomposition of Fe-γN,C phase with the formation of grain-boundary and intragranular Cr(N,C) and Fe-α phases and partial preservation of a solid-solution strengthening of austenite (a = 0.3597–0.3622 nm). Precipitation hardening is more characteristic of these specimens and their flow curves are parabolic. The complex fracture mode of the specimens subjected to ion-plasma treatment is caused by the surface solid-solution strengthening and precipitation hardening. In the surface-hardened region (where the concentrations of N, C atoms are the highest), brittle quasi-cleavage fracture occurs due to the presence of Fe-based and Cr-based precipitates and austenite oversaturated with interstitials.
科研通智能强力驱动
Strongly Powered by AbleSci AI