Effect of Direct Rolling Process on Microstructure and Mechanical Properties of the Electron Beam Cold Hearth Melting Ti-6Al-4V Alloy

Titanium alloy is a key supporting material in the field of engineering technology and high-tech, and also an extremely important national defense strategic metal material. However, the high cost limits its wider application. Direct rolling of titanium alloy melted by electron beam cold hearth melting (EBCHM) technology is considered to be an important low-cost plate production process. The rolling process has a considerable influence on the microstructure and mechanical properties of the alloy. Therefore, Ti-6Al-4V alloy melted by EBCHM technology was investigated in this study. The effects of different rolling processes on the microstructural evolution and mechanical properties of titanium alloy plates were evaluated. The results show that with the increase of deformation amount and rolling temperature, the more obvious the disintegration of lamella α and the higher the degree of equiaxation when the deformation is below the β transus. However, only dynamic recovery occurs when rolling temperature above the β transus, and lamella α does not undergo disintegration and equiaxation. With ultimate tensile strength (UTS) of 1076 MPa and elongation (EI) of 11%, the plate with 90% deformation at 950 °C has good strength and plasticity.