压实
材料科学
普氏压实试验
有限元法
振动
压缩(物理)
相对密度
铝
复合材料
本构方程
结构工程
工程类
物理
烧结
量子力学
作者
Qiang Zhou,Shutao Song,Quanfang Chen,Yuanli Bai
出处
期刊:Journal of Manufacturing Science and Engineering-transactions of The Asme
[ASM International]
日期:2020-08-06
卷期号:143 (1)
被引量:5
摘要
Abstract Aluminum powder compaction was studied using both test and simulation. Cold compaction, hot compaction, and vibration-assisted (cold) compaction tests were conducted to achieve different density ratios. First, the hot compaction test (at 300 °C, compression pressure 140 MPa) improved about 6% compared with cold compaction under the same compression pressure. Second, although the relative density ratio does not obviously improve at a vibration-assisted (cold) compaction, the strength of the specimens made under vibration loading is much better than those of cold compaction. Additionally, finite element models with well-calibrated Drucker–Prager Cap (DPC) material constitutive model were built in abaqus/standard to simulate the powder compaction process. The results of the finite element model have very good correlations with test results up to the tested range, and this finite element model further predicts the loading conditions needed to achieve the higher density ratios. Two exponential equations of the predicted density ratio were obtained by combining the test data and the simulation results. A new analytical solution was developed to predict the axial pressure versus the density ratio for the powder compaction according to DPC material model. The results between the analytical solution and the simulation model have a very good match.
科研通智能强力驱动
Strongly Powered by AbleSci AI