材料科学
结晶度
乙烯-醋酸乙烯酯
结晶
聚乙烯
醋酸乙烯酯
复合材料
聚丙烯
共聚物
熔点
无定形固体
收缩率
相(物质)
聚合物
高分子化学
化学工程
有机化学
化学
工程类
作者
Azamat L. Slonov,Ismel V. Musov,Azamat A. Zhansitov,Azamat A. Khashirov,Aslanbek F. Tlupov,Khasan Musov,Elena V. Rzhevskaya,Irina Fomicheva,Andrey I. Potapov,S. Yu. Khashirova
出处
期刊:Polymers
[Multidisciplinary Digital Publishing Institute]
日期:2023-10-18
卷期号:15 (20): 4129-4129
被引量:14
标识
DOI:10.3390/polym15204129
摘要
3D printing of polyolefins, such as polyethylene (PE) and polypropylene (PP), is of great practical interest due to the combination of high properties of these materials. However, the use of these materials in 3D printing is associated with many problems due to their high rate of crystallization, which causes shrinkage and warpage of the printed object. In this regard, blends of PE and ethylene-vinyl acetate copolymer (EVA) of various compositions were investigated for 3D printing. It was found that with an increase in the concentration of EVA, an increase in the pseudoplastic effect and amorphization of PE occurs. It has been shown that with an increase in the EVA content, the degree of crystallinity of PE decreases slightly (by 11% at a content of 80% EVA); however, a significant decrease in the rate of crystallization of PE is observed (by 87.5% at the same EVA concentration). It was found that PE and EVA are completely compatible in the amorphous phase and partially compatible in the crystalline phase, which leads to a slight decrease in the melting point of PE. The introduction of EVA also leads to a significant increase in impact strength: the maximum value is achieved at a 50/50 ratio, which is five times the value of the initial PE and two times the value of the initial EVA. At the same time, it was revealed that EVA leads to a gradual decrease in the elastic modulus and strength of PE, the change of which generally obeys the additivity rule. The resulting printing filaments are characterized by a certain ovality due to their shrinkage, which decreases with increasing EVA content and reaches a minimum value at a PE/EVA ratio of 30/70. This composition also demonstrates the lowest shrinkage of the printed sample and higher processability during printing.
科研通智能强力驱动
Strongly Powered by AbleSci AI