等离子体电解氧化
材料科学
电解质
腐蚀
化学工程
合金
氧化物
无定形固体
涂层
相(物质)
硅酸盐
环氧乙烷
镁
电化学
镁合金
冶金
复合材料
聚合物
有机化学
共聚物
化学
电极
物理化学
工程类
作者
Ashutosh Jangde,Sumit Kumar,Carsten Blawert
标识
DOI:10.1016/j.surfcoat.2022.128971
摘要
PEO coatings on AM50 magnesium alloy were synthesized under constant current mode exploiting high-concentrated mixed silicate-phosphate-based alkaline electrolyte with and without glycerine as an additive, i.e., gmix-PEO and bmix-PEO respectively. The development of PEO coatings was studied as a function of PEO treatment time for their microstructures, element compositions, phase compositions, and corrosion behaviour. For all the treatment times, gmix-PEO exhibited relatively smaller pores and lower coating thickness than bmix-PEO. The elemental composition of PEO coatings was independent of PEO processing time for both bmix-PEO and gmix-PEO. Throughout PEO processing the incorporation of Si was considerably higher than P into the synthesized coatings. MgO and Mg2SiO4 crystalline phase content was higher for gmix-PEO compared to bmix-PEO for all the treatment times studied. A complex amorphous oxide phase was observed from 4 min PEO treatment time for bmix-PEO while glycerine addition delayed the formation of the same. The study of electrochemical behaviour revealed improved corrosion performance of gmix-PEO particularly during initial immersion (up to 25 h) time for up to 4 min PEO treatment time than for bmix-PEO as glycerine addition leads to higher MgO and Mg2SiO4 phase content and thicker/compact inner barrier layer. For the final 8 min PEO processing time, bmix-PEO offered enhanced corrosion performance particularly due to its thicker coating compared to gmix-PEO.
科研通智能强力驱动
Strongly Powered by AbleSci AI