Numerical Study on Flow Separation Control for High-Lift Low-Pressure Turbine Split Blade

The low-pressure high-lift blade aims to reduce blades number for reducing manufacturing cost, but the flow separation is easy to appear on the boundary layer of low-pressure turbine cascade under operating condition with low Reynolds number, which will significantly decreases the efficiency and safety of turbine blade and even the whole engine. Flow control on boundary layer of the cascade can reduce flow separation and improve the aerodynamic performance of low-pressure high-loaded turbine. In this study, a new flow control approach called split blade is applied on the LPT (low pressure turbine) PakB. This technology is a passive flow control method by using the jet created by different pressure of two points on the blade surface to control the boundary layer separation on the suction surface. Different operating conditions were investigated including flow separation on PakB cascade without control and cascade with slot at four kinds of Reynolds number (Re = 25000, Re = 50000, Re = 75000, Re = 100000) (based on the chord length in axial direction). The outlet of the slot is located upstream of the separation point on the boundary layer which is 0.68Cax (chord length in axial direction) on the suction surface, the inclination angle of slot is 30°, the diameter of slot is 2mm. Detailed flow characteristics, separation and reattachment locations are presented at the different Reynolds numbers were presented in this paper. The results show that without control the separation location on the boundary layer of the cascade moves downstream with the increase of Reynolds number while the reattachment location moves up. The results also show that at Reynolds number is 25000, as different pressure of slots two ends is low, the jets velocity is low and the control effect is not obvious. At other three kinds of Reynolds number, the reattachment location moves up separation zones decreases due to the flow control.