Solidification cracking susceptibility of alloy 718 during additive manufacturing and evaluating method

Although hot cracks frequently occur during metal additive manufacturing (AM), there are very few fundamental studies on the cracking behaviour and susceptibility. In this study, a horizontal tensile-type hot cracking test was investigated for evaluating the solidification cracking susceptibility of alloy 718 quantitatively during AM, particularly in laser powder bed fusion. The factors influencing the cracking susceptibility were also examined. The solidification cracking was reproduced by the melting of the AMed specimen with a tensile load under conditions of heat source simulating the AM process. The critical initial tensile stress for solidification crack initiation could apply as an evaluation index for cracking susceptibility. The critical initial stress decreased with increasing the laser power. A similar tendency was observed during the melting of the powders set on tiny groove for simulating AM process. The critical strain rate for solidification cracking (CST) was derived by a thermal elastic–plastic analysis using the critical initial stress measured experimentally. The CST at the laser power of 1125 W was higher than that of 1000 W for no crack condition. Therefore, high CST corresponding to penetration shape with high laser power induce to deteriorate the solidification cracking susceptibility.