Anti-bacterial robust Ag@PDA/PEN electrospinning nanofibrous membrane for oil-water separation

Separating of oil-water emulsions under harsh conditions is a major challenge for membrane-based filtration systems. In this study, a well-stabilized electrospinning nanofibrous membrane was successfully fabricated by combining a high-performance engineering polyarylene ether nitrile (PEN) with polydopamine (PDA), and silver nanoparticles (Ag NPs). The employed PEN has comprehensive performance in thermoresistant, anti-corrode and mechanical properties, which was expected to be a robust polymer matrix. Ag NPs were loaded on PEN electrospinning nanofibrous membranes via PDA coating and in situ growth. Morphological measurements revealed a hierarchical structure of fabricated [email protected]/PEN membrane with Ag NPs formed in situ covered on the surface. The particle size of Ag NPs was mainly in the range of 50–85 nm and the diameter of PEN fiber was located at∼0.39 μm. The water contact angle (CA) of membranes increased from 30o to 130o by the increasing Ag NPs formation. As a result, the prepared composite membranes reached 4978.71 L/m2h and 99 % for permeate flux and good retention rate for oil-water emulsion separation, respectively. Moreover, the high-performance PEN further endowed the tough stability and durability of the obtained composite membranes, which can tolerate corrosive emulsions, resist high temperatures, and maintain a high separation efficiency after cycle reuse. Furthermore, the as-prepared membranes demonstrated excellent anti-bacterial properties (>99.99 %) inherited from the introduction of Ag NPs. Therefore, the comprehensive anti-corrode, anti-heat, and anti-bacterial performance provide the fabricated robust [email protected]/PEN electrospinning nanofibrous membrane a broad prospect for purifying water resources, especially industrial wastewater treatment under harsh conditions.