Thermal stability of polymers based on acrylamide and 2‐acrylamido‐2‐methylpropane sulfonic acid in different temperature and salinity conditions

Abstract Partially hydrolyzed polyacrylamide (PHPA) is the most widely used polymer in enhanced oil recovery (EOR) applications. However, under conditions of high temperature and salinity, the PHPA molecules become hydrolyzed, causing a drastic reduction of the viscosity of the polymer solution due to the presence of negative charges, making the molecules more susceptible to interactions with cations. In this sense, in order to increase the stability of these polymers, an anionic monomer more resistant to cations such as 2‐acrylamido‐2‐methylpropane sulfonic acid (AMPS) has been incorporated into the HPAM molecules. This work evaluated the thermal stability of a copolymer (acrylamide and AMPS ‐ AN125) and a terpolymer (acrylamide, acrylate, and AMPS‐FP5115) in the time course of 360 days. The tests were carried out in typical conditions of Brazilian offshore reservoirs, such as absence of oxygen, high temperature, and high salt concentration. The test method involved measurements of intrinsic viscosity in function of time and determination of the hydrolysis degree of the polymers by elemental analysis. The copolymer AN125 was more stable under the test conditions than the terpolymer FP 5115 due to the presence of a higher concentration of AMPS in the copolymer. The AMPS group was hydrolyzed to AA at a temperature of 100 °C, however, the increase in salt concentration delayed the onset of this degradation. The tests indicated that the presence of a higher AMPS content in the copolymer does not prevent the polymer from undergoing hydrolysis, but delays the polymer precipitation step in the solution.