Mechanical properties, thermal behaviors and oil resistance of epoxidized natural rubber/multiwalled carbon nanotube nanocomposites prepared via in situ epoxidation

Epoxidized natural rubber (ENR)/multiwalled carbon nanotube (MWCNT) nanocomposites were prepared via in situ epoxidation of natural rubber (NR) using a molar ratio of formic acid/hydrogen peroxide to isoprene unit at 0.75/0.75 with five loadings of MWCNTs, ranging from 0.5–2.5 parts per hundred parts of rubber (phr), at 50°C for 4 h. Based on Fourier transform infrared spectra, the epoxide content of ENR in the nanocomposites was about 32.5–33.2 mole%. Accordingly, the products were referred to ENR30/MWCNT nanocomposites. The curing characteristics, mechanical properties (tensile properties, tear strength, and hardness), glass transition temperature ( T g ), thermal stability, and oil resistance of these in situ ENR30/MWCNT nanocomposites were investigated and compared with NR and neat ENR30. The results showed that the scorch and cure times of ENR30/MWCNT nanocomposites were the longest followed by NR and ENR30. The incorporation of an appropriate amount of MWCNTs into the in situ epoxidation apparently improved the properties of NR. Among them, the nanocomposites filled with 2 phr MWCNTs exhibited the highest mechanical properties, T g , thermal stability, and oil resistance. The mechanical properties of the in situ nanocomposites were also compared with those of the control nanocomposites prepared by adding MWCNTs directly in the prepared ENR30 latex. It was found that at similar MWCNT loadings, the in situ nanocomposites exhibited higher mechanical properties than the control nanocomposites.