Fouling behavior of poly(vinylidene fluoride) (PVDF) ultrafiltration membrane by polyvinyl alcohol (PVA) and chemical cleaning method

Severe fouling to poly(vinylidene fluoride) (PVDF) membrane is usually caused as filtrating the papermaking wastewater in the ultrafiltration (UF) process. In the paper, fouling behavior and mechanism were investigated, and the low-concentration polyvinyl alcohol (PVA) contained in the sedimentation tank wastewater was found as the main foulant. Consequently, the corresponding cleaning approach was proposed. The experiment and modeling results elaborated that the fouling mode developed from pore blockage to cake layer along with filtration time. Chemical cleaning conditions including the composition and concentration of reagents, cleaning duration and trans-membrane pressure were investigated for their effect on cleaning efficiency. Pure water flux was recovered by over 95% after cleaning the PVDF membrane using the optimal conditions 0.5 wt% NaClO (as oxidant) and 0.1 wt% sodium dodecyl benzene sulfonate (SDBS, as surfactant) at 0.04 MPa for 100 min. In the chemical cleaning method, hypochlorite (ClO−) could first chain-scissor PVA macromolecules to small molecules and SDBS could wrap the fragments in micelles, so that the foulants were removed from the pores and surface of membrane. After eight cycling tests, pure water flux recovery maintained above 95% and the reused membrane was found intact without defects.