软组织
3d打印
植入
面部重建
聚醚醚酮
计算机断层摄影术
医学
显著性差异
外科
生物医学工程
口腔正畸科
材料科学
偷看
内科学
复合材料
聚合物
作者
Ahmad Fayez Ahmad,Hekmat Yacoub,Ali Khalil
标识
DOI:10.1097/gox.0000000000006029
摘要
Background: Patient-specific implants (PSIs) have been presented as an effective solution for diseases that require reconstruction. PSIs are designed to precisely fit anatomical defects or deformities in terms of shape and size. In addition to the possibility of predicting the results of surgery regarding soft tissue changes. Methods: A research sample consisting of 10 patients with facial deformities underwent maxillofacial reconstructive surgery between 2020 and 2021 in the Tishreen University Hospital, Syria. All patients underwent computed tomography scans; then, the design of the required facial implant was carried out, and the three-dimensional soft tissues were reconstructed using the ExoCad 3.0 program based on the computed tomography. The final form of the facial implant was printed from polyether ether ketone, and then surgical work was performed. The patients were followed up after 6 months. Then, a comparison was made between the virtual design and the real result. Results: The absolute difference between the expected soft tissue changes result and the actual result did not exceed three-tenths for all patients, and only two of 10 patients had measurements higher than 20%. Conclusions: This technique can be relied upon with the placement of implants to predict the outcome of the surgical procedure in terms of morphological changes in the facial soft tissues covering PSI polyether ether ketone. Therefore, it is possible to make a virtual design based on the cosmetic requirements of the patient.
科研通智能强力驱动
Strongly Powered by AbleSci AI